Fm Radio Tuner Operation - Lenco iPD-9000 DAB+ Manual De Instrucciones

IPD9000 DAB+_IB draft R03 (1).pdf IPD9000 DAB+_IB draft R03 (1).pdf
Antenna
For the best radio reception, fully extend the rod antenna located at rear of the unit.
MENU Option
In the FM radio mode, the unit allows you to select following options.
(1) Press the MENU button entering menu mode.
(2) Two options, [Scan setting] and [Audio setting] can be set by pressing the
(a) Whilst [Scan setting] is displayed, press the ENTER button to confirm the selection.
- Then press
Note:
[All stations] ----- By default FM scan stops at any available station (All stations). This
[Strong stations] ----- FM scan stops only at stations with good signal strength.
- Press the ENTER button to confirm the desired selection when [All stations] or [Strong stations]
displayed.
(b) Whilst [Audio setting] displays, press the ENTER button to confirm selection.
- Then press
Note:
[Stereo] ---- By default, all stereo stations are reproduced in stereo. For weak stations,
[Forced mono] ----- only reproduce mono audio.
- Press the ENTER button to confirm the desired selection when [Stereo] or [Forced mono]
displayed.
(3) You may press the MENU button to exit menu setting mode at any time.
Auto-scan and store Preset Stations
The unit allows you to store up to 20 FM stations for easy recall at any time.
1. Press the STANDBY
2. Press the FUNCTION button to select FM radio mode.
3. Press and hold the SCAN button until the frequency digits begin to change. The tuner will automatically
scan for stations from low to high frequency and then store them in the preset location.
Note: After each auto-scan & store operation, it will overwrite the existing preset stations by overwriting
and storing the new stations in their place.
4. To recall the preset station, press the CH +/- buttons from the remote control.
F M Radio Tuning and manual store Preset Stations
1. Press the STANDBY
2. Press the FUNCTION button to select FM radio mode.
FM Radio Tuning
3. You can have following ways to tune to a desired station:
(a) Press the
frequency figure.
(b) Press and hold the
release the button.
(c) For up-scan, press the
will tune to the next higher radio station.
For down-scan, press the
will tune to the next lower radio station.
2012-5-16 2012-5-16 21:31:25 21:27:52

FM Radio Tuner Operation

/ buttons to display [All stations] or [Strong stations].
may result in poor quality audio from distant stations.
/
buttons to display [Stereo] or [Forced mono].
this may result in poor quality audio. The audio quality can be improved
using mono.
button to turn on the unit, where the power status indicator light on.
button to turn on the unit, where the power status indicator light on.
/
buttons with 0.05MHz tuning step and tune to a desired radio station
/
buttons and tune to a desired radio station frequency figure then
button once then press the SCAN button from the remote control and it
button once then press the SCAN button from the remote control and it
8
/
buttons.