Dab / Dab+ Tuner Operation - Lenco iPD-9000 DAB+ Manual De Instrucciones

IPD9000 DAB+_IB draft R03 (1).pdf IPD9000 DAB+_IB draft R03 (1).pdf
Save preset station
4. Press the MEM button. The preset channel number appears on display and blinks.
5. To select a desired preset station number, press the
Note: Each time the station number changed, it will display the current frequency or "Empty" of that
preset station location.
6. To confirm preset location, press the ENTER button and "Preset store" displays a while then returns to
normal tuner mode. The newly tuned frequency will replace the frequency in the selected preset
station location.
7. Repeat steps 3 to 6 to store other stations, if apply.
Notes:
There is a few seconds delay when programming, after this delay time, the unit will automatically
●
switch back to normal tuner mode.
You can overwrite a preset station by overwriting and storing the new frequency in its place.
●
Recalling Preset Station
8. Press the CH +/- button from the remote control. The preset channel number and frequency appear on
display.
RDS function
The unit incorporated the RDS functions,
When the received radio station with RDS information, you may press the RDS button repeatedly from the
remote control to display the RDS information.
The unit is able to receive available DAB and DAB+ radio stations in your area.
Antenna
For the best radio reception, fully extend the rod antenna located at rear of the unit.
MENU Option
In the DAB mode, before listening to a DAB / DAB+ radio station, following section describes options which
are available for your selection, if apply.
Navigation button
In the menu setting mode, you can make use of following navigation buttons to implement the option
selection.
MENU button ---- Press to enter or exit menu mode.
/
buttons ---- Press to select / display option item.
ENTER button ----- Press to confirm selection.
MENU Options
[Full scan] ----- A full scan of DAB/DAB+ radio stations in your area. Once the scan is completed, the radio
returns to play the previously-selected station or first station on the station list.
[Manual tune] ----- Manual tune to a particular channel/frequency.
[DRC] -----Dynamic range compression (DRC), this function reduces the difference between the loudest
and quietest audio being broadcast. Effectively, this makes quiet sounds comparatively louder
and loud sounds comparatively quieter.
Note: DRC only works if it is enabled by the broadcaster for a specific station.
[Prune] ----- This removes all invalid stations indicated in the station list with a "?" in front of the station
name.
[System] ----- Factory Reset Y/N option, select "Y" to initiate a factory reset.
Full scan operation
1. Press the STANDBY
2. Press the FUNCTION button to select DAB radio mode.
3. Press the MENU button and the [Full scan] indicator displays.
2012-5-16 2012-5-16 21:31:26 21:27:52

DAB / DAB+ Tuner Operation

button to turn on the unit, where the power status indicator light on.
9
/
buttons.