Mounting your camera (optional)
DCS-8 20L
FCC ID: KA2CS82 5LA1
IC: 4216A-CS 825LA1
3(B)
CAN ICES-3 (B)/NMB-
Model: DCS-820L A1
Troubleshooting
The image is out of focus.
• You can turn the white focus ring on the front of the camera to adjust the
focus.
How do I change the accent ring?
• Rotate the accent ring counterclockwise, then lift it off. Put the new accent
ring on, then rotate it clockwise until it clicks into place.
6
• Use a 6mm drill bit to drill two holes 43mm
apart, and at least 30mm deep.
30mm
• Use a mallet to insert the wall anchors into the
43mm
holes.
• Screw the included screws into the wall
anchors.
• Place the mounting holes on the base of the
camera over the screws as shown, then slide
the camera down to mount the camera.
DCS-820L