Turbosaver TS-SV60WI Manual De Instrucciones página 12

IMPORTANT: Sous Vide circulators are designed to be used only with water.
SETUP
(clamp & pot)
Sous Vide circulator requires a 6-15L container or pot. and make sure the container or pot
capacity meets the requirement.
Firmly lock the product by clamping it on the side of your container.
SETUP
(temp./timer)
1
Plug it into the outlet. The "Power" icon and working lamp will be on and it will enter
the standby mode.Press the "Power" icon to enter the setting mode. You will hear a
sound of beep for every pressing.
2
Temperature setting. press the + or – adjust button to set the temperature.
3
Time setting. Press the "Screw" icon to set the time. You can find the timer blinks.
First press the + or – adjust button to set hour, then press "Screw" again to set the minute.
The timer will countdown when it meets the setting temperature. (there will be a signal
flash and soud of beep when reaching the setting temperature)
4
Press the "Power" icon to confirm the setting and the unit will work. If you want to
change the setting, press and hold the "Screw" icon for 3 seconds, and then repeat the
setting as above.
The unit will stop automatically when it runs out of time and an "END" icon will show on
the screen.
5
Press and hold the "Power" icon for 3 seconds to stop.
MAINTENANCE
• Always turn off and unplug the unit.
• Internal service work must be performed by certified personnel only.
12