Trouble Shooting Faq - Turbosaver TS-SV60WI Manual De Instrucciones

Maintenance (skirt/pump)
Turn the pump cap out of the lock position then pull off.
The skirt and pump cap can be placed into the dishwasher.
Cleaning the circulator
For cleaning the heating coil, pump shaft, and sensors, use dish soap, a soft tooth brush
and rinse under water. Do not rinse the top part of the circulator including the main body
in water.
Cleaning the skirt
To clean the stainless steel skirt and pump cover – place into a dishwasher or wash in the
sink with detergent.

TROUBLE SHOOTING FAQ

Noise:：
Under normal operation the system will hum due to the motor, impeller and cooling fan in
operation.
Grinding noise:：
The stainless steel skirt is loose. Push the stainless skirt up into the guide groove and turn
to the right until you hear a click. With the skirt secure, the noise will go away. There also
might be the chance the stirring shaft was inadvertently bent. If this is the case, unscrew
the bottom pump disk and gently push the impeller until it is centered.
Slurping noise ：
Your pump has formed a water vortex like when you are emptying out a bathroom sink
or tub. Add more water or gently disturb water with a spoon. There is no sure way to eli-
minate a vortex from forming due to the pump rotation but usually will go away on its own.
14