Technical Specifications - Turbosaver TS-SV60WI Manual De Instrucciones

Gurgling + Woosh noise: ：
The pump is sucking air - add more water. You should also see small bubbles in your tank.
Food damage: ：
The pump's water jet is cracking eggs or damaging fish fillets: Turn the pump outlet to
face the container wall; this will greatly temper the flow of the pump output. It is also good
practice to bag eggs to prevent them from being "blown" around in certain containers.
System will not turn on:
Check power plug and breakers.
Low water level alarm:
Add more water – the water level can be dropped during operation by the pump due to
water turbulence.
Low water level alarm turns on after a few seconds of operation: ：
Add more water – The pump generates "waves" – sometimes these waves will cause the
water level at the sensors to fluctuate up and down. The waves sometimes drop the wa-
ter level right under the sensor and will cause a low water alarm. This is normal and you
just need to add more water.
Temperature read does not match thermometer:：
Sous Vide circulators are calibrated to a scientific platinum primary standard which is far
more accurate than store thermometers.
Lights in house are slightly flickering when system is on ：
This is normal as the circulator is modulating power.
Error code EE1 will be appeared in below situation with alarm sound:
1
No water in tank.
2
Water below minmum level.
3
Appliance in situation of short cuicuit.

TECHNICAL SPECIFICATIONS

Power rate:
220 ~ 240V, 50HZ, 800W
Temperature range:
Temperature Stability:
Circulation pump:
The vacuum sealing system #1
0°C ~ 90°C
+/- 0.1°C
12 LMP Max
15