Palazzetti ECOFIRE INSERIMENTO IDRO 18 Generalidades - Advertencias - Instalación - Mantenimiento página 35

6.1.1 Installation without pedestal
The stove can be installed directly onto the oor
of a replace.
Procedure:
Open the door;
remove the safety bracket (A - fig.6.3) by
undoing its two bolts
lower the lever to release the sliding mechanism
(B - g.6.3)
extract the stove by gripping the interior of the
combustion chamber
disconnect the water delivery and return pipes
support the stove with a metal bar (1/2'' x 2 m)
tted into the holes behind the boiler (A - g.6.4)
undo the four bolts (two on each side) securing
the stove to its sliding rails ( g.6.4)
position the basement and anchor it to the
replace oor with anchor bolts ( g.6.5)
hook the stove up ( ue, plumbing)
t the stove back onto its telescopic rails with
its bolts
reconnect the water delivery and return pipes
push the stove into its seat until you are sure
the automatic locking mechanism has engaged
( g.6.6)
restore the safety bracket and secure it with its
two bolts (A - g.6.3)
close the door
The bottom of the basement must be unobstructed
to permit combustion air and cooling air to enter the
combustion chamber and cladding respectively.
Fig. 6.5
Fig. 6.4
A
Fig. 6.6
35