Cleaning And Maintenance - Ferm OTM1004 Traducción Del Manual Original

removing
● Place the machine on a table with the mounting
point (3) facing upwards.
● Loosen the Allen screw (7) using the Allen key
(5).
● Remove the spacer (8).
● Remove the scraping knife (12) from the
mounting point (3).
● Mount the spacer (8).
● Tighten the Allen screw (7) using the Allen key
(5).
USE
Switching on and off (fig. A)
● To switch on the machine, slide the on/off
switch (1) to the front.
● To switch off the machine, slide the on/off
switch (1) to the rear.
Setting the speed (fig. A)
The speed adjustment wheel is used for setting
the speed. The speed adjustment wheel can be
set to 6 positions.
The ideal speed depends on the application and
on the material to be worked.
2
Do not set the speed during use.
● Turn the speed adjustment wheel (2) to the
required position.
Hints for optimum use
● Clamp the workpiece. Use a clamping device
for small workpieces.
● Draw a line to define the direction in which to
guide the accessory.
● Firmly hold the machine by the grip.
● Switch on the machine.
● Wait until the machine has reached full speed.
● Place the accessory on the workpiece.
● Slowly move the machine along the pre-drawn
line, firmly pressing the accessory against the
workpiece.
● Do not apply too much pressure on the machine.
Let the machine do the work.
● Switch off the machine and wait for the machine
to come to a complete standstill before putting
the machine down.

CLEAnIng AnD MAInTEnAnCE

4
Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
Replacing the accessories (fig. B)
Worn or damaged accessories must be replaced
immediately.
2
Only use sharp and undamaged
accessories.
● To remove the accessory, proceed as described
in the corresponding section.
● To mount the accessory, proceed as described
in the corresponding section.
wArrAnTy
Consult the enclosed warranty terms.
EnVIrOnMEnT
Disposal
8
The product, the accessories, and the packaging
must be sorted for environmentally friendly
recycling.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2002/96/EC
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
7