Overheat Protection; Cleaning And Maintenance; Safety Information; Cleaning - CASO DESIGN B 800 Manual Del Usuario

14.3 Overheat protection

In order to prolong the device's service life, an overheat protecting unit is installed. If the
motor runs too long or overloaded, the temperature reaches the warning value and the
motor will stop automatically. Pull out power supply plug and wait for the motor to cool
(about 20 to 30 minutes), then use again.
If you have any problem with this device, do not disassemble it by yourself. Always contact
the service department or after-sale service department.

15 Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.

15.1 Safety information

Attention
Please observe the safety instructions, before cleaning your device
► Unplug the device when not in use and before any cleaning.
► Never immerse the device, cord or plug in water or other liquids and do not place in the
dishwasher.
► The blades are really sharp. Handle them with care.

15.2 Cleaning

1. It is recommended to use the machine often to keep the motor clean and dry.
2. Fill the blender jar until half with hot water and add a few drops of mild detergent. Mix on
level 2 for 2 minutes. Rinse the jar with lukewarm water and dry it after this.
3. Please keep the device at a dry and wll ventilated place to avoid that the motor is
getting wet and moldy.
4. Don't dip device into water. Only wipe it with a wet cloth. The other parts (lids, middle
part of lid/top lid etc.) can be directly cleaned with water.

16 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

16.1 Security advices

Attention
► Repairs of electrical appliances must be carried out by qualified personnel who are
trained by the manufacturer.
► Repairs performed by untrained persons may result in considerable hazards for the user
and damage the machine.
32