Troubleshooting; Disposal Of The Old Device; Guarantee - CASO DESIGN B 800 Manual Del Usuario

16.2 Troubleshooting

Problem
The device does not
start.
The unit has shut down.
Attention
► If above mentioned steps don't solve the problem, please contact your
customer service.

17 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for their
functionality and safety. If these were put in the non-recyclable waste or were handled
incorrectly, they could be detrimental to human health and the environment. Therefore, do
not put your old device into the non-recyclable waste under any circumstances.
Utilise the collection point, established in your town, to return and recycle old electric
►
and electronic devices. If necessary, contact your town hall, local refuse collection
service or your dealer for information.
Ensure that your old device is stored safely away from children until it is taken away.
►

18 Guarantee

We provide a 24 month guarantee for this product, commencing from the date of sale, for
faults which are attributable to production or material faults.
Your legal guarantee entitlements in accordance with § 439 ff. BGB-E remain unaffected
by this. The guarantee does not include damages, which were incurred as a result of
improper handling or use, as well as malfunctions which only have a minor effect on the
function or the value of the device. Consumables, transit damages, inasmuch as we are
not responsible for these, as well as damages, which were incurred as a result of any
repairs that were not performed by us, are also excluded from the guarantee entitlements.
This device is designed for use in domestic situations and has the appropriate
performance levels.
Any use in commercial situations is only covered under the guarantee to the extent that it
would be comparable with the stresses of being used in a domestic situation. It is not
intended for any additional, commercial use.
Solution
Please check whether the power plug is properly plugged.
Please check whether the assembly is done according to
assembly methods.
The overheat protection was activated.
Pull out power supply plug and wait for the motor to cool
(round about 30 minutes), then use again.
Please note
33