Tool Installation; Tool Operation; Depth Of Drive Adjustment - DUO-FAST DF350S Manual De Funcionamiento

TOOL INSTALLATION

Your Duo-Fast tool comes ready for immediate use
and can be installed by following these steps:
1. SAFETY - All tool operators and their immediate
supervisors must become familiar with the
operator safety instructions before operating the
tool. The instructions are on page 4 of this manual.
2. Included with each tool is the operating manual
and schematic. Keep these publications for future
reference. An ownership registration card is also
included. This card must be completed and
returned to Duo-Fast immediately to register your
ownership.
3. The plastic cap in the air inlet of the tool must
be removed before the male fitting is installed.
The fitting must be a male pneumatic type that
discharges the air from the tool when the air line is
disconnected.
4. Install a filter/regulator/lubricator unit, with a gauge
as close as practical to the tool, preferably within
ten feet. Refer to the Air Systems section of this
manual for air hose requirements and lengths. In
general, no other special installation is required.
5. If the operator is working at a bench or table, it is
usually best to run the air line underneath the
bench. A small tray under the benchtop can hold
the fastener supply and the tool when not in use.
6. If this tool does not work when it is first connected,
do not try to make repairs. Call your Duo-Fast
representative immediately.

TOOL OPERATION

Depth of Drive Adjustment

The depth of drive adjustment is made by
turning the thumbwheel on the work contact
element.
If the tool is overdriving (the fastener head
is driven below the work surface), the work
contact element should be moved downward.
If the fasteners stand up (the head is not flush
with the surface), the work contact element
should be moved up.
Adjust the work contact element until the
fastener head depth meets job requirements.
WORK
CONTACT
ELEMENT
5
ROTATE
THUMBWHEEL
IN EITHER
DIRECTION