Startup; Check Connections; Turning On The System; Check Output Values - Balluff BIW1-A/C/E/G310-M-P1-S115 Serie Manual De Instrucciones

BIW1-A/C/E/G310-M_ _ _ _-P1-S115
Micropulse Linear Transducer in Profile Housing
5

Startup

5.1

Check connections

Although the connections are polar-
ity reversal protected, components
can be damaged by improper con-
nections and overvoltage. Before
you apply power, check the connec-
tions carefully.
5.2

Turning on the system

Note that the system may execute
uncontrolled movements when first
turned on or when the transducer is
part of a closed-loop system whose
parameters have not yet been set.
Therefore make sure that no haz-
ards could result from these
situations.
6

Versions (indicated on part label)

BIW1-A310-M0450-P1-S115
Type:
Interface: A = 0...+10 V
Ordering
code: BIW_ _ _ _
6.1

Included in shipment

Transducer with condensed guide
and 2 mounting brackets.
6
english
5.3

Check output values

After replacing or repairing a trans-
ducer, it is advisable to verify the
values for the start and end position
of the sliding rod in manual mode.
5.4

Check functionality

The functionality of the transducer
system and all its associated com-
ponents should be regularly
checked and recorded.
Supply voltage 3 = DC 24 V potential isolated
Electr. connection: with connector S115
Profile form factor
Nom. length (4digits): M = metric in mm
C = 0...20 mA
E = 4...20 mA
G = -10...+10 V
6.2

Available lengths

The following nominal stroke
lengths are available:
0075, 0100, 0130, 0150, 0175,
0225, 260, 0300, 0360, 0375,
0400, 0450, 0500, 0600, 0650,
0750
Other stroke lengths on request.
5.5

Fault conditions

When there is evidence that the
transducer system is not operating
properly, it should be taken out of
service and guarded against unau-
thorized use.
6.3 Accessories (optional)
➥ Fig. 4-3
Connectors
straight: BKS-S115-PU-_ _
right angle: BKS-S116-PU-_ _