Grounding Instructions - SCHOLTES LTE S3 XL60HZ Instrucciones De Uso

EN
Fig. 5-13
Connecting to a waste disposal unit (no air gap)
Make the connection upline from the siphon of the drain
line and at least 400 mm (15-3/4") above the floor on
which the dishwasher will be installed.
1. Remove the cover of the waste disposal unit (ref. A
fig. 5-14).
2. Connect the dishwasher drain hose (ref. B fig. 5-14) to
the waste disposal unit inlet (ref. C fig. 5-14), using the
wide spring clamp (ref. D fig. 5-14).
* Available from any plumbing stockist
Fig. 5-14
5.2.2 Electrical connections and warnings
Check that the voltage and the frequency of the mains
match the ratings on the name plate of the appliance
positioned on the inner edge of the door.
12
In the event of damage to the supply cord, have it
replaced by the manufacturer or an authorized technical
service centre.
This appliance must be grounded. in case of a
malfunction of fault, the ground reduces the risk of
electrocution by providing the electrical current with an
alternative, less resistant path. This appliance is fitted
with a supply cord containing a ground wire and plug. fit
the plug into a suitable socket, installed and grounded in
compliance with the laws in force in the country of
installation.
Before making electrical connections, disconnect the
mains power supply from the work area.

Grounding instructions

This appliance is fitted with a cord with ground wire and
plug. Fit the plug into a suitable socket, installed and
grounded in compliance with the laws in force in the
country of installation.
Check that the mains supply in the place of installation
complies with the regulations in force in the country of
use, and that it is correctly grounded.
An incorrectly connected ground wire may generate the
risk of electrocution. If in doubt as to the correct
grounding of the appliance, call in a qualified electrician
or the technical assistance service. Do not change the
plug attached to the appliance. If the plug is not suitable
for the socket, call in a qualified electrician to fit a
suitable plug.
The plug at the end of the power cord and the
corresponding socket must be of the same type and
must conform to current regulations governing electrical
appliances. The plug must be accessible after
installation. Never remove the plug by pulling on the
wire. If the power cord is damaged, have it replaced by
the manufacturer or an authorized service centre.