Switching Off; Energy Saving And Environmental Respect; Removing The Dishes - SCHOLTES LTE S3 XL60HZ Instrucciones De Uso

•
press the button twice twice twice twice to select washing in the lower
twice
rack. rack.
rack. rack. This is confirmed by the relative indicator light rack.
(ref. 9b fig. 7-02);
•
press the button thr thr thr thr three times ee times ee times ee times to return to the standard ee times
full load full load full load condition (washing in both racks, both full load full load
indicator lights off).
When washing in just the lower rack lower rack lower rack lower rack is selected, the lower rack
cutlery basket can be separated cutler cutler y basket can be separated y basket can be separated y basket can be separated and just half
cutler cutler y basket can be separated
PROGRAM DELAY
(only on some models; available for all programs except
soak).
The "Pr Pr Pr Pr Program delay ogram delay ogram delay" function delays the beginning of ogram delay ogram delay
the washing program up to 9 hours from the moment in
which programming takes place. This makes it possible
to use the dishwasher at a certain time of day.
Before programming a delay, open the door of the
dishwasher, select the required washing program (see
para 2.2 "Setting the washing program and switching on
and off"). Select the day by pressing the Pr Pr Pr Pr Program delay
button (ref. 10 fig. 2-02); each time you press the button,
the display increases the delay before the appliance
1 hour. . . . . 1 hour 1 hour
starts by 1 hour 1 hour

7.2.8 Switching off

At the end of the program, the dishwasher emits a short
beep and the indicator lights of the fourth and fifth
program (ref. pr. 4, pr. 5 fig. 7-04) flash.
Turn off the appliance by opening the door and pressing
the on/off button (ref.1 fig. 7-02).
Fig. 7-04
If it is necessary to open the door during the washing
cycle, the program will be interrupted, the relative
indicator light will continue to flash and a beep will
indicate that the cycle has not terminated. Wait for about
1 minute before closing the door and continuing with the
program. When the door closes, the program will start
from where it was interrupted. This operation should be
performed only if necessary as it could cause irregular
program performance.
8 ENERGY SAVING AND
lower lower lower
lower
ENVIRONMENTAL RESPECT
•
•
•
the the the the
•
just half just half used. just half
just half
•
•
8.1 Reducing the consumption of
detergent and respecting the environment
The phosphates contained in dishwasher detergents are
harmful to the environment. To avoid using excessive
amounts of detergent and to save on electricity:
•
ogram delay ogram delay ogram delay ogram delay
•

9 REMOVING THE DISHES

At the end of the washing program, wait at least 20
minute before removing the dishes in order to allow
them to cool. To prevent any water droplets on the upper
rack from falling onto the dishes in the lower rack, empty
the lower rack first and then the upper one.
Always try to run the dishwasher fully loaded.
Do not wash the dishes under a running tap.
Use the most suitable washing program for each
type of load.
Do not pre-rinse.
If available, connect the dishwasher to a hot water
system with a temperature of up to 60°C (140°F).
When possible, skip the drying cycle by opening the
door after washing: the air and the residue heat will
dry the dishes to perfection.
Separate the more delicate items from those that are
more resistant to aggressive detergents and high
temperatures;
Do not pour the detergent directly onto the dishes.
EN
27