Dimensions Of Dishwasher; Installation And Hook-Up; Leveling - SCHOLTES LTE S3 XL60HZ Instrucciones De Uso

4 DIMENSIONS OF DISHWASHER

EN
(See fig. 4-01)
Model A (height)
85,8 cm ÷ 91 cm
LTE
33,81" ÷ 35-55/64"
85,8 cm ÷ 91 cm
LFD
33,81" ÷ 35-55/64"
Tab. 4-01
Fig. 4-01

5 INSTALLATION AND HOOK-UP

During installation, take care not to injure yourself on the
sharp edges of the appliance.
Remove the polystyrene rack blocks. Position the
appliance in the chosen installation position. The sides
and rear of the appliance can lie against kitchen units or
walls. If the dishwasher is installed next to a heat source,
separate it with a heat insulating panel in order to
prevent overheating and malfunctions. To assure stability,
only install built-in appliances under continuous
worktops, securing them to the adjacent kitchen units or
worktop with screws.
Building-in a dishwasher underneath a ceramic hob is
absolutely forbidden. A dishwasher can be built-in
underneath a conventional hob provided there is no
break in the kitchen worktop, and the dishwasher and
hob are installed and secured correctly, so that no
hazards are generated.
Make sure the dishwasher has been correctly
installed and grounded by a qualified fitter.
8
B (width) C (depth)
59.7 cm ÷ 59.9 cm 54,7 cm
23-1/2" ÷ 23-37/64" 21,55"
59.7 cm ÷ 59.9 cm 54,7 cm
23-1/2" ÷ 23-37/64" 21,55"
This safety requirement must be met. In case of
doubt, call in a qualified fitter. The manufacturer
declines all responsibility for damage to persons or
property resulting from the failure to ground the
appliance or from a defective ground connection.
Before proceeding with installation, disconnect the
main power supply from the work area.
Only for free-standing models
•
It is strictly forbidden to mount a cooktop over a
freestanding dishwasher.
•
If the appliance is not in a niche and can therefore be
accessed on one side, cover the door hinge area for
safety reasons (cutting hazard). Covers are available
as accessories from specialized retailers or from the
Technical Service Centre.
• To build in the dishwasher, purchase the relative kit
from specialized retailers or from the Technical
Service Centre.

5.1 Leveling

5.1.1 Mounting the feet (only for some models)
Turn the appliance upside-down (see fig. 5-01).
Tighten the nut (see ref. A fig. 5-01) onto the threaded
pin (see ref. B fig. 5-01) of the foot and then fit the
supplied washer; do this on both feet.
Screw the feet onto the appliance until the washers
touch the base; the two feet must be manually adjusted
to the same height to prevent excessive differences in
height between one foot and the other.
Put the appliance back on its feet.
Two people wearing safety gloves are needed to turn the
dishwasher upside-down.
Fig. 5-01