Bissell POWERLIFTER 2019 Serie Guia Del Usuario página 9

Replace the Brush & Belt
1
Unplug vacuum, turn over and
unscrew Philips head screws
to remove bottom cover. This
model has 6 screws.
Clearing a Clog
1
Remove the hose
from the back of the
vacuum by twisting
it to the left. Remove
any debris that may
have gotten clogged.
2
Lift roller straight
out. If the belt is not
broken, remove roller
from inside of the
looped belt.
2
Check the foot hose
on the back of your
vacuum down towards
the bottom. Remove the
screw from the foot hose
and check for clogs.
3
Replace the brush roll and
belt by looping the belt
over the motor shaft and
the brush roll. Line up the
end caps and pull the brush
forward into place. This will
stretch the belt. Once the
brush roll is installed, place
the bottom cover back on
and replace the screws.
3
Check the air passageway on
the bottom of your vacuum.
Remove the bottom cover and
the brush. Remove any debris.
www.BISSELL.com
9