Assembly - Bissell POWERLIFTER 2019 Serie Guia Del Usuario

Assembly

WARNING
Do not plug in your vacuum until you are familiar with all instructions and operating
procedures.
The only tool you will need to assemble
your vacuum is a Phillips screwdriver.
1
Place the upper
handle onto the base
and push it down.
Then attach the
handle with the 2
screws that are taped
to the handle in a
plastic bag.
3
To experience
freshness as you
vacuum, locate the
Febreze® scent tag
at the bottom of
the vacuum bag.
Carefully pull the tab
along the perforated
lines in the center of
the scent tag.
NOTE: Only a portion of the
overwrap should be removed.
5
NOTE: The Pet Hair Eraser® Tool does not store on-board.
NOTE: The crevice tool can be found inside the extension wand. You can remove
it to use it and put it back to store it neatly out of your way when you're finished.
Now wrap
the hose
through the
hose clip and
connect the
hose wand to
the foot hose
down at the
bottom of the
vacuum.
2
4
Next, insert the end of the hose into the back
of the vacuum and twist to lock it into place.
Put your accessory tools on the
vacuum and you're ready to go!
Extension
Wand
Wrap the power
cord around the
cord wrap clips
and clip the end
of the plug to
the power cord.
Pet
Dusting
TurboEraser®
Brush
Tool
www.BISSELL.com
5