FanWorld FW6 Serie Manual De Instalación Y Usuario página 59

4. DISPLAY
*
Press this button to turn on/off the display. This is for the
convenience of users who are unconformable sleeping with
the backlight on.
5. iFEEL
* Press this button to set the temperature display on the
remote controller to ambient temperature and press this
button again to set it to preset temperature.
6. TIMER
*
With the unit ON, press this button to set OFF timer or with
it OFF to set ON timer.
*
Press this button once, a "ON(OFF)" will flash. Press "
" "to set the number of hours in which the unit will be turned
ON/OFF, with an interval of 0.5 hour if less than 10 hours, or
1 hour if longer than 10 hours , and a range of 0.5-24 hours.
*
Press it again to confirm the setting, the "ON (OFF)" will
stop flashing.
*
If the timer button is not pressed longer than 10 seconds after
the "ON (OFF)" start flashing, the timer setting will be exited.
*
If a timer setting is confirmed, pressing this button again will
cancel it.
Note: When a ON timer is set, all function buttons (except SLEEP,
DISPLAY and iFEEL can't be set ) are valid and when the ON time
set is up, the unit will operate as preset.
7. HEALTH / iCLEAN
This function performs a self cleaning the indoor unit. When the 'iClean' function is
activated, the unit operates initially mode cooling fan at low speed during this period
condensing water entrains the powder battery. then the unit switches to heating
mode the fan at low speed, to dry the battery inside the unit. Finally the drive
switches to cooling to finish completely dry.
This button also serves to remove the reminder cleaning air filter, code
'CL' which is activated when the machine reaches the cumulative
operating 360h. Press 10 times the 'HEALTH' button to remove the counter.
To turn off the meter, press the 'HEALTH' button 5 times.
or
8.
* Each time the "
increase by 1℃ and each time the "
decrease by 1℃.
*
The temperature setting ranges from 16℃ (60℉)～32℃(90℉).
Note: The temperature cannot be set in AUTO or FAN mode, thus
these two buttons are not functional.
This unit must be installed by a professional according: RD 795/2010, RD 1027/2007 and RD 238/213.
REMOTE CONTROLLER
" is pressed, the temperature setting will
59
" or
" is pressed, it will