Emptying The Tank - Thetford C260 Manual De Usuario

EN
The range of available Toilet Care products may
vary for each country.
4 Use of your toilet
Turning the bowl
Opening the blade
Electric Blade (if applicable)
Press the flush button to activate the
control panel. Then push the Electric Blade
button. The blade will open or close electrically.
Flushing the toilet
Electric Ventilator (if applicable)
By activating the control panel, the
Electric Ventilator will start automatically; it will
shut off automatically after about 5 minutes.
The Electric Ventilator button will flash to
show that this function is active. To stop the
ventilator, press the Electric Ventilator button.
Press the button again to re-start the ventilator.
To optimise its function, activate the Electric
Ventilator before you use your toilet.
You can turn this bowl to a
desired position
(max. ±90 º). Close the
cover and use both hands
to rotate the bowl as
illustrated.
The toilet can be used with
the blade open or closed.
To open the blade, slide the
blade handle sideways as
illustrated. Make sure you
always close the blade
completely after use.
Press the flush button once
to activate the control
panel. Then press the flush
button for several seconds
to flush the toilet.
Ordinary toilet paper can
cause clogging. Use Aqua
Soft toilet paper instead. This
toilet paper is super-soft,
dissolves quickly, prevents
clogging and makes it easier to
empty the waste-holding tank.
Level indication
You can check wether your waste-holding tank has
a 1-level or a 3-level indication. Make sure the tank
is empty and place it back properly. Then activate
the control panel. If no level indication light lights
up, your toilet has a 1-level indication. It will only
indicate a full tank. If a green level indication light
immediately lights up, your toilet has a 3-level
indication. It will indicate empty, half full and full.

5 Emptying the tank

Waste-holding tank
When the red light of the level indicator on the
control panel lights up, you need to empty the
waste-holding tank. Remove the tank via the
service door. Then take it to an authorised waste
disposal point. Empty the waste-holding tank via
the pour out spout.
To empty the tank without splashing, press
and hold the vent button with your thumb
while the pour out spout is pointing downwards.
Waste Pump-Out system (if applicable)
By activating the control panel, this
button automatically lights up. Press the
button to empty the waste-holding tank into the
vehicle's central waste tank. The button flashes
while the waste is being pumped and stops
flashing when all waste has been transferred.
(±1.5L of waste is left). If the central waste tank
is too full (only measured when this tank has a
level indicator), the button flashes rapidly and
no pump-out is possible until you have emptied
the central waste tank.
6