Long PID Names
Long PID Names allows the user to enable/disable the tool scrolling
the complete PID name on the bottom line of the display while viewing
Live Data or viewing Freeze Data.
From the System Setup menu, use the ▲UP or ▼DOWN
arrow keys until Long PID Names is highlighted, then press
ENTER.
Select ON or OFF as desired using the ▲UP or ▼DOWN
arrow keys, then press
r e t u r n t o S y s t e m Setup.
State OBD Check (Emissions)
The State OBD Check function is used to display a basic status of the
vehicle's OBD system.
The State OBD Check function has the following areas:
MIL STATUS ON or OFF
Number of Codes Found
Number of Monitors OK
Number of Monitors Inc
Number of Monitors N/A
9 State OBD Check should be done with the key on engine
running (KOER) due to showing MIL status.
9 The number of codes found are both Confirmed and
Permanent codes. Pending codes are not included.
9 The number of Monitors that are either OK, INC or NA are
only Since DTCs Cleared and not This Drive Cycle.
9 Refer to Read Codes and I/M Monitors for more detailed
information about the results.
ENTER to save or BACK to
12