Drain Hose Kit: Fitting Instructions - Hoover DX H9A3TCEX-S Manual De Instrucciones

2.
DRAIN HOSE : FITTING
INSTRUCTIONS
To avoid emptying the water container after
each drying cycle, the water can be discharged
directly to a waste water drain pipe (the same
drainage system as household sinks). Water
Bye-Laws prohibit connection to a surface
water drain. The waste water drain pipe should
be located adjacent to the tumble dryer.
The kit consists of:1 hose and 1 tap.
WARNING! Switch off and remove the
tumble dryer plug from the electricity supply
before carrying out any work.
Fit he t Hose a
1. Flip the machine
slowly to the right
side.
2. The waste water
pipe is situated at the
right-hand side of the
machine (see the
picture). A grey hose
connects to the bridge
at the left hand side of
the machine. Using
pliers, remove the
pipe retaining clip
from the bridge.
3. Pull the hose off the
bridge connection.
s Follows:
1
2
3
4. Attach the black
hose from the kit,
(using the connector
a n d p i p e c l i p s
supplied), to the hose
removed from the
bridge connection.
5. Connect the new
drain hose to the waste
Water pipe.
6. Once the machine is
in place, check the
bottom to ensure that
the new hose does not
kink when pushing the
tumble dryer into
position.
Connect to the mains
electricity supply.
Caution: If the product is in different side,
wait at least 4 hours before switching on so
that the oil can flow back into the
compressor. Failure to do this could result
in damage to the compressor.
8
4
5
6 6