Pentair Water Pool and Spa IntelliFlo VF Guia De Inicio Rapido página 11

Cycle Start and Stop
®
12:15 12:15
Filter Filter
9:00 21:00
Start Cycle 1 Stop Cycle 1
Enabled Enabled
Time and Contrast Menu
®
12:15
MENU Time/Contr 12:15
Time/Contr 5
Contrast Level
Setting: Start/Stop Cycle – Clock/Screen Contrast
Each Cycle has two screens, one for Start Cycle and one for Stop Cycle.
Press Down arrow
®
Press Down arrow
Repeat this procedure for every Cycle.
Press Down arrow
The Start Cycle 2 will be enabled only if 2 cycles per day have been entered under previous screen.
You can program up to four start and stop cycles per day.
The more time the Intellifl o VF is given to operate, the less power and fl ow will be needed for
turning over the pool.
Setting Clock
® Press Select to access Set Time.
Make sure to set AM/PM or 24H correctly.
IntelliFlo can store the correct time for up to 96 hours after power is shut off.
After 96 hours, IntelliFlo VF's clock must be reset.
Adjusting Screen Contrast
Press Down arrow
Screen contrast levels can be set from 0-9.
Avoid setting at 0 unless you are unable to read the screen due to bright sunlight.
to access Start Cycle and set starting time.
again to access Stop Cycle and set stop time.
to scroll to Time/Contr.
to scroll to Contrast.
11