Publicidad
Idiomas disponibles
Idiomas disponibles
Service System Soon
Over Voltage Alarm
Under Voltage Alarm
Over Current Alarm
Main Failure Alarm
Drive Temp Alarm
Priming Alarm
Sleep Mode
Suction Blockage
18
Features – Alerts/Alarms/Suction Blockage
Occurs when pump discharge pressure has reached programmed clean fi lter pressure.
Yellow warning LED will stay on until backwash cycle is run.
Occurs in any mode when voltage spikes.
Occurs in any mode when voltage drops below 170 volts.
Usually associated with motor failure or locked rotor.
Occurs when motor calls for more current than needed.
Occurs when power is fully lost.
Occurs when drive gets too warm or cold. Pump will not shut off, but will change speed to cool
itself off or warm itself up.
Occurs when IntelliFlo VF cannot stabilize fl ow for selected priming duration.
Unit conserves power when set routines are completed faster than programmed times.
If pump suction is fully blocked, IntelliFlo shuts off immediately (within one second).
IntelliFlo will also shut off after a few seconds of dead-heading. IntelliFlo will come back on in
30 seconds and slowly ramp up. This function should be tested with all new installations by
directing fl ow to one suction and covering it with a piece of material, such as a rubber bath mat.
(Check your local codes for appropriate testing procedures.) DO NOT COVER SUCTION
WITH HAND! This alert is deactivated in Manual Mode.
For more detailed instructions on IntelliFlo
IntelliFlo
Installation and User's Guide, P/N 357220. This manual can be viewed and downloaded at
VF
www.intellifl o.eu or www.pentairpooleurope.com.
IntelliFlo
®
Quick-Start Guide
P/N 357222
VF
®
installation, operation, and troubleshooting, refer to the
VF
U.S. Patent Pending
Publicidad
Capítulos
