Priming Menu - Pentair Water Pool and Spa IntelliFlo VF Guia De Inicio Rapido

Priming Menu

®
MENU 12:15
Priming Priming
Setting Priming Flow
®
Priming 12:15
17 m3/h 17 m
Max Priming Flow
8
Pool Volume – Water Temperature – Priming
The Priming settings determine how long IntelliFlo VF will try to prime before it reports an error.
This is a critical setting for proper operation. The lower the time setting, the quicker a priming
error is reported if the system is diffi cult to prime.
The Priming range can be set from 1 minute to 15 minutes.
mechanical seal will withstand approximately 15 minutes of attempted priming before before
damage occurs. If the pool is plumbed correctly,
seconds without removing the strainer.
substantial amount of air is in the system, IntelliFlo should prime in 60 to 90 seconds.
Important: IntelliFlo VF will prime every time it starts. If the priming fl ow is set too high, equipment
damage could occur. If set too low, IntelliFlo will not prime. Establishing the correct priming fl ow may
require some trial and error, but always keep the fl ow as low as possible for cost savings and safety.
Press Down arrow to scroll to Priming menu. Press Select to enter the Priming
menu.
Press Select to access "Max Priming Flow" value.
The available range is from 7 - 36 m
Press Left arrow and Right arrow
Change values by pressing Up arrow
When value is set, press Enter
Priming time determines how long you want IntelliFlo to attempt to prime before reporting an
error. Time can be set from 1 to 15 minutes.
IntelliFlo VF should prime in less than 30
If the strainer has been removed for cleaning and a
3
.
to select digit to modify.
and Down arrow.
to confi rm value and program.
Note: An IntelliFlo VF