Enabling Features - Pentair Water Pool and Spa IntelliFlo VF Guia De Inicio Rapido

Features 3 – 9
Enabling Features 3 – 9
Setting Flow Rate
Setting Start/Stop
Features – Flow Duration/Rate/Start–Stop Time
Features 3 through 9 enable you to program specifi c fl ows for timed operation.
These features are fully controlled by IntelliFlo's internal clock. You will need to program a fl ow rate
and start/stop time for each feature.
Note: Feature 3 through 9 program times cannot overlap.
When a feature is running, IntelliFlo will monitor m
All sensors are active during any Feature 3 – 9 cycle.
Features must be enabled before they will operate.
To enable, press Select + Down arrow
Flow Rate for Features 3 – 9
Press Down arrow to access Set Flow.
Press Select to access the Flow setting.
Press Left arrow and Right arrow
Change values by pressing Up arrow
When value is set, press Enter
Times for Features 3 – 9
Press Down arrow to select Start Time or Stop Time Setting.
Press Select to access the setting.
Press Left arrow and Right arrow
Change values by pressing Up arrow
When value is set, press Enter
3 /h and subtract time from the fi lter cycle.
and Enter to save the setting.
to select digit to modify.
and Down arrow.
to confi rm value and save changes.
to select digit to modify.
and Down arrow.
to confi rm value and save changes.
13