Modulated Output - Pentair Water Pool and Spa IntelliFlo VF Guia De Inicio Rapido

Modulated Output

(M.O. Flo)
Enabling M.O. Flo
Setting M.O. Flo
Flow Rate
Setting M.O. Flo
Run Time and
Interval Settings
14
M.O. Flo will provide specifi c fl ow during regular intervals for a period of time defi ned by the user.
The Modulated Output feature automatically increases pump fl ow to allow the system heater to check
the water temp and switch on if necessary. This feature also allows fl ow control fl exibility if fi lter cycle
fl ow is less than needed for certain devices. M.O. Flo also allows you to program fl ow intervals that can
be used for water effects. You will need to enable M.O. Flo, and set the fl ow rate, run times, and intervals
between run times. M.O. Flo will operate only during the "Filter Mode" time cycles.
Press Up arrow or Down arrow
Press Select to access M.O. Flo menu settings.
Press Select and Down arrow
Press Down arrow to access Set Flow setting.
Press Select to access setting.
Press Left arrow and Right arrow
Change values by pressing Up arrow
When value is set, press Enter
Press Down arrow to access Set Run Time or Set Interval Time.
Press Select to access setting.
Press Left arrow and Right arrow
Change values by pressing Up arrow
When value is set, press Enter
to select M.O. Flo.
to enable. Press Enter to save.
to select digit to modify.
and Down arrow.
to confi rm value and save changes.
to select digit to modify.
and Down arrow.
to confi rm value and save changes.