BaByliss G960E Manual De Instrucciones página 49

2. Plug the other end of the adapter into a power socket.
> The ON/OFF button turns on and is orange in colour
(FIG. 2).
3. Switch on the appliance by pressing the ON-OFF button (FIG. 3).
> The ON-OFF button turns green.
> The power level 1 LED indicator is on. Level 1 is
programmed by default when the appliance is switched on
(FIG. 4).
4. Place the appliance Skin Sensor on the area of skin where you wish
to perform treatment (FIG. 16)
> The intensity level LED indicator(s) switch on and flash,
showing that the appliance has successfully detected the
phototype of the area of skin to be depilated and adjusted
the power level automatically (FIG. 17)
5. Press once on the trigger to confirm (FIG. 18)
> The intensity level LED indicator(s) stop flashing (FIG. 19).
6. Position the application surface on the area of skin detected and
keep the application surface still, in position, to ensure total contact.
> The Ready LED flashes when the appliance is correctly
positioned on the skin and ready to release a light pulse
(FIG. 20)
7. Press on the trigger to release a light pulse onto the skin. (FIG. 21)
N.B.: You may feel a slight hot sensation and tingling.
8. Move the application surface to another area of skin and press the
trigger to release another light pulse. Take care not to overlay the
light pulses.
Only if there are absolutely no side effects following the previous
session, you may increase the power level manually to increase
effectiveness.
If you experience any discomfort, reduce to the previous power level.
Note: if a not recommended level has been reached using the manual
control with respect to the skin colour determined by the Skin Sensor,
47