Fence Angle Adjustment; Adjustment For The Clamping System; Air Pressure Regulator For The Vertical Clamping System; Important - Inmes IM-4P Manual De Intrucciones

7.3.1 - Fence angle adjustment

If during the test above the corner of the frame remains open forward or
backward, it is possible to adjust the fence angle of about 1°, 06 Fig. 23, and rotate
clockwise or anticlockwise the knob 03 Fig. 23 on the left fence in Fig.23 till the right
adjustment is founded.
a) Loosen two screws from the left fence;
b) Turn clockwise or counterclockwise the button 03 Fig. 23 until you reach the
desired angle;
c) Tighten the two screws;
d) Make sure to adjust just the left fence. Do not adjust the angle of the right
fence, it is adjusted at the factory.

7.4 - Adjustment for the clamping system

7.4.1 - Air pressure regulator for the vertical clamping system

The working pressure must be adjusted to the hardness of the moulding to be
assembled. The pressure regulation allows changing the clamping pressure of moulding to
be assembled. When the working pressure is too high this may cause poor joining and
moulding crashing. When the working pressure is too
low this may cause incomplete insertion of wedge into
the frame.
We do recommend setting the air pressure
regulator 01 Fig. 23A at 6 BARA (85 PSI). Attach the
compressed air source to the machine with appropriate
"quick disconnect fitting". The source must be filtered
and lubricated and not exceed 6 BAR (85 PSI). To
increase the air pressure turn it clockwise and
counterclockwise to decrease the air pressure.
The source should be filtered and lubricated and not exceed 6 BAR (PSI).

7.4.2 - Vertical clamp adjustment

To perform the height adjustment of the Vertical clamp 02 Fig. 24 proceed as
follow:
a) Press the button 01 Fig. 24 and adjust the pressure pad 02 Fig. 24 over the
frame. We do recommend adjusting the height 10mm (3/8") above the
frame to avoid accident fingers crushing and correct insertion of the
wedges Fig. 25;
b) Release the button once you have reached the proper position;
INMES INDUSTRIAL LTDA - GRAMPEADORA IM-4P – UNDERPINNER IM-4P
ENSAMBLADORA IM-4P

Important:

Fig. 23A
40