Options Of Joining - Inmes IM-4P Manual De Intrucciones

Slide the joystick 01 Fig. 29 to the rear position for the insertion of the first nail
and place both frames pieces against the fence Fig. 33:
a) Set the front clamp 03 Fig. 31 about 10mm from the rabbet of the frame;
b) Adjust the vertical clamp height 06 Fig. 31;
c) The IM-4P it is a versatile machine and can be operated as listed on next page;
d) Important: If it is necessary to use 2 or 3 nails proceed as follow: with the
clamping system activated, press the joystick to insert the nails. Release the
joystick and press again to insert the second nail and repeat this operation to
insert as many nails you want.

7.6 - Options of joining

The IM-4P can be ordered with the following configurations:
a) 2 stage foot pedal and 1 stage manual Fig. 34;
b) 2 stage foot pedal and 1 stage manual and/or 2 stages manual and 1 stage foot
pedal Fig. 35;
INMES INDUSTRIAL LTDA - GRAMPEADORA IM-4P – UNDERPINNER IM-4P
ENSAMBLADORA IM-4P
Fig. 32
Fig. 34
Fig. 33
Fig. 35
43