Inmes IM-4P Manual De Intrucciones página 50

c) Once you have the nailing head out of the machine place it on a flat surface
and use a 4mm Allen wrench to loosen and remove the 4 screws as shown in
figs. 45 and 46;
d) Clean the inside of the nailing head using a cloth and a drop or two of
pneumatic oil. After cleaning, wipe down the nailing head with a dry cloth. Then
put one drop of pneumatic oil on the inside of the nailing head;
e) Before mounting the nailing head we suggest you use a flat surface (like a
mirror) Fig. 47 in order to give a precise alignment of the two parts. If the top
and sides are not in precise alignment, it will not work properly;
f) When attaching the nailing head over the drive pin make sure to place it
according to Fig. 45 ;
INMES INDUSTRIAL LTDA - GRAMPEADORA IM-4P – UNDERPINNER IM-4P
ENSAMBLADORA IM-4P
Fig. 43
Fig. 45
Fig. 44
Fig. 46
47