Horizontal Clamp Adjustment - Inmes IM-4P Manual De Intrucciones

Fig. 26

7.4.3 - Horizontal clamp adjustment

The front clamp has a series of holes in the flat bar Fig.27. Lift the bar to take it
out of its initial position and make it move forward and backward. To lock the bar it is
sufficient to insert it into the proper peg located in the middle of the guide channel.
Proceed as follow to position the front clamp properly:
a) Remove the bar from the peg and move it forward up to reach the moulding to
be assembled as shown in Fig. 27;
b) Lower the bar to allow the insertion of tracking screw and the locking in the
next position;
c) Place the front clamp at 3/8" (10mm) in front of the frame rabbet. Fig. 28.
INMES INDUSTRIAL LTDA - GRAMPEADORA IM-4P – UNDERPINNER IM-4P
ENSAMBLADORA IM-4P
Fig. 24
The IM-4P has triangle and round pressure pads
available as shown in Fig. 26: V02 (01), V03 (02), D50
(03) and D25 (04). These optional pads offer versatility
when joining complex profiles.
Fig. 25
41