Maintenance - Troy-Bilt 01924 Manual Del Propietário

Maintenance
5
GENERAL MAINTENANCE
RECOMMENDATIONS
The Owner/Operator is responsible for making sure that
alt periodic maintenance tasks are completed on a timely
basis;that all discrepancies are corrected; and that the unit
is kept clean and properly stored. NEVER operate a
damaged or defective generator.
Engine Maintenance
See engine owner's
manual for
instructions.
_ AUTION! Avoid prolonged or repeated skin
contact with used motor oil. Used motor oil has
been shown to cause skin cancer in certain
laboratory animals.Thoroughly wash exposed areas
with soap and water.
KEEP OUT OF REACH OF CHILDREN. DON'T
POLLUTE. CONSERVE RESOURCES.RETURN
USED OIL TO COLLECTION CENTERS.
li[l_llt_l_=m= e]W_I F_jI
Generator Maintenance
Generator maintenance consists of keeping the unit clean
and dry. Operate and store the unit in a clean dry
environment where it will not be exposed to excessive
dust, dirt, moisture or any corrosive vapors. Cooling air
slots in the generator must not become clogged with snow,
leaves or any other foreign material.
NOTE: DO NOT use a garden hose to clean generator.
Water can enter engine fuel system and cause problems. In
addition, if water enters generator through cooling air slots,
some of the water will be retained in voids and cracks of
the rotor and stator winding insulation.Water and dirt
buildup on the generator internal windings will eventually
decrease the insulation resistance of these windings.
To Clean the Generator
_ AUTION! NEVER insert any object or tool
through the air cooling slots, even if the engine is
not running.
• Use a damp cloth to wipe exterior surfaces clean.
• Use a soft bristle brush to loosen caked on dirt or oil.
• Use a vacuum cleaner to pick up loose dirt and debris.
• Use low pressure air (not to exceed 25 psi) to blow
away dirt. Inspect cooling air slots and opening on
generator.These openings must be kept clean and
unobstructed.
Data Tag
Data tag information is very importantif you need help from
our Customer Service Depatment or an authorized service
dealer.
The data tag (Figure 9) is located on the engine support on
the mumer side of the generator. For future reference, please
copy the model, revision, and serial number of the generator
in the space below.
I
MODEL
REV NO
SERIAL
AC VOLTS
AC AMPS
AC WATTS
DO VOLTS
DCAMPS
Single Phase 160 Hz / 3600 RPM
Rated at 40 "C / Class F insulation
]
]
J
I
]
O ___T!(m___ -B!_LT
Tmy-Bilt@ isa registered trademarkof
MTD and is usedunderlicense to
Bdggs & StraKon
Power Products Group, LLC
Jefferson, WI 888-611-6708
] MADE IN U.S.A.
,...Copy Model
Number Here
_Copy Revision
Here
Copy Serial
Number Here
t