Troubleshooting - Troy-Bilt 01924 Manual Del Propietário

Troubleshooting
7
TROUBLESHOOTING
Problem
No AC output is available, but
engine is running.
When loads are connected,
engine runs good but bogs down.
Engine shuts down during
operation.
Solution
I. Reset circuit breaker.
2. Check and repair.
Cause
I. Circuit breaker is open.
2. Poor connection or defective
cord set.
3. Connected device is bad.
4. Fault in generator.
I. Short circuit in a connected load.
2. Generator is overloaded.
3. Shorted generator circuit.
Out of gasoline.
Load is too high.
3. Connect another device that is in
good condition.
4. Contact Authorized Service
Facility.
I. Disconnect shorted electrical
load.
2. See "Don't Overload Generator".
3. Contact Authorized Service
Facility.
Fill fuel tank.
Engine lacks power. See "Don't Overload Generator".
t