Norlake Kold Locker Serie Manual De Instalación página 32

Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
W -i m
alk n ainTenance
2940 Hwy 14 W, Rochester, MN 55901
AdJUSTABLE HINGE
Nor-Lake 26", 30", & 36" wide walk-in doors are provided with an adjustable hinge. The adjustable hinge provides
the ability to square a door within the door jamb.
If a door requires adjustment:
Open the door and you will find a small chrome plug button, on the edge of the door behind the upper hinge.
Before any adjustment you must first slightly loosen the screws on the hinge strap on the door. Then pop off the
chrome plug button. Now you can access the adjustment screw. You should only make minor adjustments and
then close the door to view if the adjustment rectified the situation. When complete replace the chrome plug and
re-tighten the screws on the hinge strap.
NOTE: On doors with a kick plate you may have a center (3rd) hinge. In this case there is a 2nd adjustable
hinge. You will need to loosen the screws on both the top and center hinge(s) and make minor adjustments in
both areas.
REPLACEMENT Of THE MAGNETIC dOOR GASKET ASSEMBLy
For your convenience and safety, it is advisable to remove the entire door assembly
from the walk-in cooler or freezer before attempting to replace the door gasket.
Prepare a smooth, clean surface on which the exterior surface of the door assembly
can be placed without marring or scratching the finish.
dOOR ASSEMBLy REMOvAL - ALL fOAMEd WALK-IN COOLER OR fREEZERS
WITH CAM LIfT HINGES
NOTE: For doors equipped with a spring hinge, see the door removal instructions label on the interior
of the door near the top hinge. When removing the door assembly from any walk-in, solicit the aid of
an assistant during the door removal and replacement procedures.
1. Open door to dwell position, stopping at approximately 120°.
2. Put mark on floor to indicate position of door, see sketch.
3. Lift door off frame.
4. To replace door, line up door with mark on floor.
5. Place hex hole in hinge straps over hex rods and lower door.
RESETTING SPRING HINGES
For the top spring-loaded hinge, you will need to reset the spring/hexagon pin. With the door installed,
closed and locked, remove the screws from the spring loaded hinge strap on the door only. You will
need to hold the hinge strap against the door to prevent the strap from springing out towards you
after the screws are removed. Remove the strap portion from the door by pulling upward. Hold the
strap portion above the remainder of the hinge so that the strap is flat against the door. Bring the
strap portion back down towards the door so that it meets the hexagon pin. You have now reset the
spring. Insert the screws back into the strap and door. Note: Under normal conditions, the spring has
no tension when the door is closed.
30
© 2014 Nor-Lake, Inc 10/14 Rev. G 132617