Norlake Kold Locker Serie Manual De Instalación página 9

Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
SECTION LATCHES
All wall, corner, ceiling and floor panels are joined and locked together by the
mechanical action of section latches which are integrally foamed into the panels
near the perimeter edges. A section latch consists of two halves – a lock housing
which contains a cam actuated locking arm, or hook, and a strike housing which
contains the engagement pin. Both housing halves are securely anchored in the
foam core of the panel. The lock housing is always located in the male-formed
edge and the strike housing will be found in the female-formed edge of the panel.
TO OPERATE LATCHES
Hex wrench provided in
hardware bag
7
2940 Hwy 14 W, Rochester, MN 55901
1. Insert the hex wrench
(packed in the hardware
bag) through the access
hole in the interior
panel metal into the hex
opening of the section
latch. Turn wrench in
a counterclockwise
direction to ensure
that the lock is fully
unlatched
2. Push the sections
tightly together and turn
the wrench 1/4 turn in a
clockwise direction. This
will engage the locking
arm (hook) over the pin in
the strike housing.
© 2014 Nor-Lake, Inc 10/14 Rev. G 132617
s l
ecTion aTches
• Fully extended cam lock
3. Continue turning the
wrench to a full stop
(approximately 3/4 of a
complete turn from the
unlatched position) to
complete the locking
operation.
Latches on some panels
will have to be turned
counterclockwise to
activate the locking cam.
These latches will be
designated by a "TURN"
sticker.