Installing The Batteries; Battery Precautions; Care And Maintenance; Setting Up The Remote - One for All OARC05G Guia Del Usuario

The OARC05G Universal Remote Control by One For All is a
perfect way to simplify home entertainment. It lets you control
up to five of your home entertainment devices from a single,
easy-to-use remote.
Take a minute to watch the mini-DVD that comes with the
OARC05G—it gives you a tour of the remote's features. Then
come back to this manual to set up the remote for your home
entertainment system.

Installing the Batteries

This remote needs 2 new AA alkaline batteries (not included).
1. Remove the battery cover from the back of the remote.
2. Match the batteries to the + and - marks inside the battery
case, then insert the batteries.
3 Press the battery cover back into place.

Battery Precautions:

• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
• Always remove old, weak or worn-out batteries promptly
and recycle or dispose of them in accordance with Local and
National Regulations.

Care and Maintenance

• Keep the remote dry. If it gets wet, wipe it dry
immediately.
• Use and store the remote only in normal temperature
environments.
• Handle the remote gently and carefully. Don't drop it.
• Keep the remote away from dust and dirt.
• Wipe the remote with a damp cloth occasionally to keep
it looking new.
• Modifying or tampering with the remote's internal
components can cause malfunction and invalidate its
warranty.

Setting up the remote

There are two ways to program this remote to control your
devices: by entering the code directly or by searching through
the codes to find the one that controls your device. Try the
Direct code setup first.

Direct code setup

1. Find the code for your device in the Code list. Codes are
listed by device type and brand name. The most popular
code is listed first. Make sure your device is switched on (not
on standby).
2. Press the device key on this remote for the device you wish
to set up.
3. Press and hold down the SET key until the
blinks twice (the key blinks once, then twice).
2
(power) key