Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
EN
WARNING:
Electrocution could occur if you handle the plug or appliance with wet hands. Do not
handle plug or appliance with wet hands.
WARNING:
Damage could occur to machine if openings are blocked. Do not put any object into
openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything
that may reduce air flow.
WARNING:
Injury could occur to the operator or the machine if used without the dust bag and/or filters.
Do not use the machine without the dust bag and/or filters in place.
WARNING:
Injury to the operator and/or damage to the machine could occur when cleaning on stairs,
unless extra caution is used. Use extra caution when cleaning on stairs.
WARNING:
To prevent possible electrical shock, always use a 3-wire electrical system connected to the
electrical ground. See "Grounding Instructions".
WARNING:
To reduce the risk of fire, electric shock, or injury:
• Do not leave appliance when plugged in. Unplug from outlet when not in use and
before servicing.
• Do not pick up anything that is burning or smoking, such as cigarettes, matches, or
hot ashes.
• Turn off all controls before unplugging.
120 Volt Machine
Instructions For Connection
To The Power Supply
And The Electrical Ground
This machine must be connected to the electrical
ground to protect the operator from electric shock. The
machine has an approved power cord with three con-
ductors and a plug with three terminals. Connect the
plug to a receptacle that has three holes and is con-
nected to the electrical ground. The green (or green
and yellow) conductor in the cord is the ground wire.
Never connect this wire to any terminal other then the
ground terminal.
This machine uses a 120 volt AC 60 cycle electrical
circuit. Make sure you have the correct frequency and
voltage before connecting the power cord to an outlet.
The machine has a plug as shown in Figure 1. If a
receptacle connected to the electrical ground as shown
in Figure 1 is not available, have one installed by an
electrical contractor. Do not use an adapter.
WARNING:
To prevent possible electric
shock, protect the machine
from rain. Keep the machine
in a dry building.
WARNING:
To prevent possible electric
shock, always use a 3-wire elec
trical system connected to the
electrical ground.
WARNING:
Do not cut, remove or break the
ground pin. If the outlet does not
fit the plug, consult your electrical
contractor.
WARNING:
Have worn, cut or damaged cords
and plugs replaced by an autho-
rized service person.
-4-
Ground Pin
Figure 1
®
Operator's Manual (EN) STV-20/20D
Clarke
Plate
Screw
Outlet must be
connected to
the electrical
ground
Publicidad
