Ating Data; O Perating Conditions; Afety Instructions To Be Observed On Commissioning; Achine - SUHNER MAX 40 Documentación Técnica

2.2.2 B
Arrier Air
Screw the nipple tightly into the mounting flange. Connect
hosing to the pneumatic connections, and connect a
permanent supply of treated compressed air complying
with DIN ISO 8573-1, 4.4.4 at 0.7 bar gauge pressure .
Please note that the barrier air must be supplied
for the duration of acute contamination, i.e. pos-
sibly for a time after the end of machining.
2.3 r

Ating dAtA

Maximum speed
Maximum torque
Concentricity
Tool holder
Pneumatic screw connection
Motor power
-1
50Hz 3000min
-1
50Hz 1500min
-1
50Hz 1000min
-1
60Hz 3600min
-1
60Hz 1800min
-1
60Hz 1200min
Nominal motor speed 50Hz
60Hz
Type of motor protection
Working speed (without FU) 50Hz
Weight
Paint coating
2.4 O
perAting cOnditiOns
Temperature range during operation
Maximum relative air humidity
Barrier air
Motor power
-1
6000min
400Nm
0.01mm
HSK 63 / ISO 40
G1/8
1.5 / 3 / 5.5kW
1.5 / 3kW
1.5kW
2.2 / 3.6 / 6.6kW
2.2 / 3.6kW
2.2kW
-1
1000 / 1500 / 3000min
-1
1200 / 1800 / 3600min
IP55
-1
583-6000min
-1
60Hz 700-7200min
approx. 70kg
RAL 5012
+20 to +50°C
90% at +30°C
65% at +50°C
0.7bar
230-400/460V, 50-60Hz
2.5 s
Afety instructiOns tO Be OBserVed On
cOmmissiOning
Before all work on the machine, it must
first be disconnected from the power sup-
ply.
Only a qualified person familiar with the safety regulations
may start up the machine.
Always conduct test runs without workpieces.
Check the sense of rotation before starting the machine.
The operator must make sure that the components are
integrated and operate safely in the machine.
Only a qualified person may connect the electrical power
supplies in accordance with the local regulations.
The local grounding regulations must be observed and
implemented, and this implementation inspected.
Do not start the machine until the spindle has come to a
stop.
Use only suitable tools, and never modify tools for an ap-
plication they have not been designed for.
After transport, all electrical and mechanical connections
must be examined for damage and loosening, and any
remedial measures taken.
The machine's working area must be unobstructed and
secured against unauthorized access.
When internal cooling is used, please observe the instal-
lation instructions issued by the manufacturers of the at-
tachment and rotating union.
The motor's and spindle's sense of rotation may be
checked only when there is no tension in the belt. Cor-
recting a wrong sense of rotation involves swapping over
any two of the phase conductors.
The motor cable's shielding must be connected to the
motor housing over a large area at the terminal board.
3. h
anDling
3.1 m

Achine

The machine is delivered adjusted with the
drive configuration specified in the order.
Keep the machine clean!
/o
PEration
29