Ools; P Reventive Maintenance - SUHNER MAX 40 Documentación Técnica

key anticlockwise, lower the motor with the belt pulley.
Remove screw completely (3). Draw off the motor's belt
pulley (4).
Loosen screws, and remove the cover (1). Loosen
setscrew and remove with locknut (2). Remove belt pulley
(3). Remove belt (4).
Loosen screws, and remove the motor.
Loosen screws, and remove the covers.
Fit covers with screws.
Fit motor with screws (1). Fit belt pulley and belt (2). Fit
the screw (3).
Note the correct belt tension (see section 4.3)!
3.2 t

OOls

Handle tools and attachments with care, keep
them clean and sharp, and observe the manufac-
turer's instructions on the use of coolants and tool
receivers.
Use the attachments intended for each application. Do
not trim attachments for applications they have not been
designed for.
Always use speeds and feed rates assigned to the attach-
ment and material, and do not exceed the machine's and
the tool's max speed.
Never remove chips with your bare hand, but always use
e.g. hooks, etc.
4. s
ErvicE
4.1 p
reVentiVe mAintenAnce
As soon as maintenance or repair work
starts, disconnect the machine from the
power supply, and secure it against acci-
dental reactivation. To perform work on the motor (e.g.
/m
aintEnancE
31