Maintenance Instructions - Desoutter SLE Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
application (refer to the ESP 7 Servicing and Operating
Instructions).
Note: Default rotation is clockwise (RHD), this can be
changed to anti-clockwise (LHD) in the ESP7 "SETUP
– MODE" parameters.
WARNING
IMPORTANT : SLE037
At low speed (speed adjustment 30%) the
number of revolutions of the output shaft is
not constant.
In order not to affect the lifespan of the
engine do not to exceed the torque of
3.7Nm.
To operate the tool using "Push start" :
Auto – Push start tools:
ESP 7 TOOL programmed PUSH
ESP 7 MODE programmed PUSH
● Forward:
- Hold tool around the red (grip) section and then
press the tool against the fastener until the
operation has finished.
● Reverse:
- Hold tool around the red (grip) section, first press
and hold the reverse button and then press the
tool against the fastener until the operation has
finished.
ESP 7 TOOL programmed PUSH
ESP 7 MODE programmed COMBI
● Forward or Reverse:
- Hold tool around the red (grip) section, position
the tool onto the fastener, press and hold the
Forward button / Lever / Trigger, (Or Reverse
button for Reverse) and then press the tool
against the fastener until the operation has
finished.
To operate the tool using manual mode :
ESP7 TOOL programmed MANU
● Forward or Reverse:
- Hold tool around the red (grip) section, position
tool onto the fastener and press and hold the
Lever or Trigger for Forward operation (Or
Reverse button for Reverse), until the operation
has finished.
The fixing is tightened to the required torque set
by adjusting the tension on the clutch spring (On
mechanical clutch tools), or when the programmed
current has been achieved on the current controlled
tools. (Both clutch adjustment and Current Parameter
value has to be established using suitable torque
measuring equipment to achieve the required torque).
After a tightening or loosening operation, the
tool is available to start again after:
Auto Push - Start tools:
● Lifting the tool away from the fastener. (Button /
Lever / Trigger can be held pressed).
10/2014
Manual and Angle Head tools:
● Releasing and re-pressing the Forward Button /
Lever / Trigger or Reverse button.
Information on trigger operation (Pistol Grip Tools):
● Single operation trigger On / Off (not progressive)
Torque adjustment (To be set up using suitable torque
measuring equipment to achieve the required torque).
Mechanical Clutch:
● As depicted on the exploded diagram
Current Control:
● Current Parameter(s) to be set up. (Refer to the
ESP 7 Servicing & Operating Instructions).

MAINTENANCE INSTRUCTIONS

● Service should be carried out at intervals of 500
hours' use.
● Regularly clean and inspect cable & tool for
damage, if found replace.
● Overmould should be wiped clean with a general
purpose, non-aggressive degreasant.
When disposing of components, lubricants,
etc... ensure that the relevant safety
procedures are carried out.
●Indicates direction of dismantling.
13 / 44
6159936270
Issue no: 08
Series: G

Publicidad

Tabla de contenido
loading

Tabla de contenido