Operating Mode; Maintenance Instructions - Desoutter EPBC8-1800-10S Manual Del Usario

6159920270_14_
● Connect the controller to the
Ethernet network by plugging the
Ethernet cable into port 1 located
on the controller bottom panel.
● Go to the menu ""Main menu/Configuration/
Controller/Peripherals/Network.
● Check or change the controller IP address.
● Go to the menu "Main menu/Configuration/
Tightening unit/BT parameters/Network
parameters.
● Enter the communication port.
● Refer to the CVI3 Vision user
manual at http://resource-center.
desouttertools.com.

OPERATING MODE

When the tool is powered on, the Desoutter logo
is displayed and the LEDs are blinking.
● Wait for a few seconds while the software is
being initialized.
● Refer to the user manual 6159921030 at
http://resource-center.desouttertools.com to
learn how to set up and use the functionalities
of the software embedded in the tool.

MAINTENANCE INSTRUCTIONS

Maintenance should be performed by qualified
personnel only.
● Prior to any maintenance task, disconnect the
tool.
Overhaul and preventive maintenance is
recommended at regular intervals once
per year or after maximum 1,000,000
tightenings depending on which occurs
sooner.
Assembly and disassembly
● When disassembling the tool electronics, take
extra care for the wires when pulling out the
connectors.
● When disassembling the tool front assemblies,
take care for the torque transducer wires.
● Follow standard engineering practices and
refer to figures/exploded view for the mounting
of component subassemblies.
● Prior to putting the equipment back into
service, check that its main settings have not
been modified and that the safety devices
work properly.
Meaning of the pictograms
Left hand thread
When reassembling, apply the
recommended glue
When reassembling, tighten to the
required torque
When reassembling, lubricate with the
required grease or oil.
Lubrication
● Do not apply too much grease on gears or
bearings; a thin coat shall be sufficient.
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of the
manufacturer's liability.
According to Directive 2012/19/
CE concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled.
● Contact your Desoutter
representative or consult the website
"www. desouttertools.com" to find out
where you can recycle this product.
10 / 92
English
03/2019