CLIPIC STREPPER ST50 Manual Del Usuario página 94

Running-in
AVOID CONSTANT LOW SPEED
Operating the engine at constant low speed (light load) can cause parts to graze and not seat
in. Allow the engine to accelerate freely through the gearsprovided that the recommended
maximum limit is not exceeded. Do not, however, use full throttle for the first 1600km
ALLOW THE ENGINE OIL TO CIRCULATE BEFORE RIDING
Allow sufficient idling time after warm or cold engine start up before applying load or re-
viving the engine. This allows time for the lubricating oil to reach all critical engine compo-
nents.
PERFORM YOUR FIRST, AND THE MOST CRITICAL, SERVICE
The first 1,000km service is the most important on that your motorcycle will receive. Du-
ring running-in and all the other parts will have seated in. At this time all adjustment should
be made, all fasteners should be tightened and the dirty oil be replaced.
Timely performance of the first 1,000km service will ensure optimum service life and per-
formance of the engine.
NOTICE
The first 1,000km service should be performed as outlined in the maintenance sche-
dule section of this owner's manual. Pay particular attention to the caution and war-
ning in maintenance schedule section.
94