Installing Battery; Charging Battery - Soundcast VG10 Manual Del Usuario

ENGLISH | How to use VG10
Congratulations and thank you for your purchase of the Soundcast VG10.
Please read the operation instructions carefully before use.
Quick Start Guide
Box Includes:
3.5mm AC Wall Battery
analog Charger
audio with
cable Adaptor
clips

Installing Battery

1. Using a Phillips #3 screwdriver, unscrew and
remove battery cover located on bottom of VG10
2. Connect the battery to the VG10 connector which
will only fit in the proper direction
3. Route the battery wires
4. Re-install battery cover
4

Charging Battery

Before initial use, charge battery for at least 5 hours to
full capacity. To ensure battery longevity and maximum
performance of the system, the battery should always
be charged prior to mobile operation.
1. Plug-In the included AC Wall Charger to AC power
and connect the other end to the VG10 DC In port
located behind the port protection cover of the VG10.
Pack
2. The VG10 can be operated from AC Wall Current
even when battery is fully discharged
3. Charge time is approximately 4-5 hours from fully
discharged battery.
4. Playtime varies from depending upon volume level.
Power ON
Power OFF
Battery Low
Fully Charged
Fully Charged
Error- Cannot Charge
Orange Power/
Charging
Indicator LED
Status Power LED
Solid Orange
Off
Slow Blinking Red
Charging Solid Red
Off (if power off)
Solid Orange (if power on)
Fast Blinking Red
Ports, Connections and Inputs
Capacitive Touch Control Keypad
NFC (Near Field
Communication)
Location
Comfort-Grip
Carry Handle
Weather Resistant
Charging & Access
Ports Location
Battery access panel
Charging & Access Ports
WIFI LED DC IN
USB/
15V 2.4 A
WIFI BUTTON AUX IN
SERVICE RESET