Maintenance And Care; Possible Faults - Schick Dental S2 Master Manual Del Usuario

10. Maintenance and care

!
Do not clean milling machine and milling spindle with
CAUTION!:
The chuck should be cleaned and re-greased once in a while, depending on how dirty it is
see "Replacement of chuck" (point 9; page 13)
- As the C2 milling spindle has no commutators, carbon brushes or ventilation parts,
no further maintenance is required.
- All guideways are maintenance free.
For cleaning please use only a brush!
Before cleaning please switch the milling machine off and withdraw mains plug !

11. Possible faults

- Should the milling spindle be overloaded, respectively, jammed, for safety
reasons the unit will switch off.
- turn speed selection
machine is ready for use again.
- alternatively switch mains switch
If after that the machine is not working please check the fuses and replace them if necessary.
→
The fuses (230V 2x T2AH250V art.no.:3106) (100-115V 2x T4AH art.no.: 7306) are to
be found beside the socket for the mains cable.
Should it not be possible to abolish the faults please contact SCHICK directly
back to "0-postion"; select the desired speed and the
(2)
and
(18) off
14
Maintenance and care
Possible faults
again.
on
compressed air!