Andis LCL-2 Manual De Uso página 4

SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR HOUSEHOLD USE
OPERATING INSTRUCTIONS
CHARGING CLIPPER
The 4.5V 1.2A AC adapter is only intended for use
with Andis Model LCL/LCL-2 lithium-ion clipper. Remove
the clipper and AC adapter from the carton. Plug the AC
adapter into a 100-120V, 50-60 cycle AC outlet, or as
noted on the unit. Plug the adapter cord directly into the
receptacle on the bottom of the clipper (Figure A). The
clipper ON/OFF switch must be in the OFF position for
the battery to charge. The green light on the clipper will
turn ON when the clipper is charging. When clipper is
fully charged, the green light will turn OFF.
The clipper has not been charged at the factory.
Please charge the clipper for 3-5 hours before FIRST use for maximum
performance. When battery is fully charged, clipper can be used for up to
2 hours of continuous run time. After first use, clipper will fully charge in a
minimum of 90 minutes.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you know
is working).
2. Make sure ON/OFF switch on the clipper is OFF.
3. Check to make sure adapter cord is plugged firmly into clipper.
4. If failure to charge still exists, return clipper to Andis or an Andis authorized service
station for examination and repair or replacement.
CORDED OPERATION
If the clipper powers OFF in the middle of a clipping job, the adapter cord can be
attached to continue use in corded operation. When the clipper is running with the
adapter cord attached, the green light will remain ON if the battery is not fully
charged. The clipper will not charge while in use with the cord attached. After using
your Andis clipper, rewrap cord loosely and store in a safe place.
USING THE ATTACHMENT COMBS
(Some models do not have combs and sizes will vary by kit)
You can set the blades for a longer cut by using any of the attachment combs made
for your Andis clipper. The combs mount easily; simply slide the cutter blade teeth
into comb and slide the comb down. To remove, simply slide off (Figure B). These
attachment combs guide hair into the blades and give you precise control of hair
lengths. The length of trim is indicated on the attachment comb. Use the chart
4
A