Information On Initial Start-Up; Test Run Initial Start-Up; Notes On The First 20 Operating Hours; Operating Instructions - Zipper Maschinen ZI-RPE120GYN Manual De Instrucciones

16.1 Information on Initial Start-up

Note that the machine is delivered without engine oil and fuel. Make sure that the
fluif containers are filled before the machine is put into operation for the first time.
ATTENTION: The machine does not start until the engine oil has been refilled to
the upper limit.
Also check the excitation oil level before initial operation!

16.1.1 Test Run Initial Start-up

 Let the machine run idle for about 3 minutes.
 Watch out for abnormal noises.
 Do you pay attention to the exhaust fumes (too black, too white)?

16.1.2 Notes on the first 20 operating hours

In order to optimize the life expectancy of your machine, the following points should be observed:
 Spare the engine for the first 20 operating hours (this also applies to used engines after
extensive maintenance). This means lower speed and lower maximum working load than
during normal operation.
 Change the engine oil after the first 20 hours of operation.
16.2

Operating Instructions

 Always ensure an optimum oil level.
 Never tighten the cable while the engine is running. This will damage the engine.
 The pull mechanism for changing the engine speed is limited by an adjusting screw. This is
factory set. Never change this setting on your own, you could overload the motor.
 Under no circumstances should you operate the machine on slopes of more than 20°, as
even with an optimum oil level the engine may not be supplied with sufficient lubrication.
 In the direction of the vibratory plate advance and within a range of one meter around the
vibrator, nobody but the operator must stand.
 During the compaction and raising of an earthwork, the soil should first be compacted
about 10 to 15 cm inside the edge two to three times, then the edge is compacted.
 If you shake the soil inside a building, the vibrating plate should not touch the base
structure, the reinforced concrete piles, the base of the machine, the underground pipes,
etc. The vibrating plate should not be in contact with the base structure.
 When working inside the building, the vibratory plate or eccentric block must not strike
against the walls.
 If several vibrator plates are used simultaneously on one surface, the parallel distance
between the machines should not be less than five metres and the distance between the
front and rear machines should not be less than ten metres.
 If the machine is working in an environment that is just about perfect, e.g. on soft or
uneven ground, make sure to reduce the horsepower to the lowest level to prevent the
machine from sinking. On slopes (max. 20° allowed!!!), make sure that the machine does
not tip over.
 Pay increased attention to the following particularly dangerous areas:
o
o
ZIPPER MASCHINEN GmbH
ZI-RPE120GYN
When working in tunnels, good ventilation must be provided to prevent
accidents. In addition, there must be a functioning control system for the
functioning of the fresh air supply.
The stability of the machine should be taken into account when working and
parking the machine in order to avoid dangers.
www.Zipper-Maschinen.at
N O T I C E
29