Festo EGSA Instrucciones De Utilizacion página 24

EGSA
Fasten the EGSA on the threaded holes 5
S
(diagonally) with at least 4 screws and 2
centring sleeves or by means of kits.
Tighten the fastening screws evenly.
S
EGSA−...
Screw
Max. screw−in
depth L
Centring sleeves
Tightening torque
Fitting in a vertical or sloping position
Warning
Uncontrolled moving masses can cause
injury to people or damage to property
(danger of fingers being squashed).
If there is a power cut or a spindle nut
fracture inside the EGSA, the work mass
will fall down.
S Make sure that the EGSA is driven only
by motors with an integrated spring−
loaded holding brake.
S Check whether additional external safety
measures against spindle nut fracture
are necessary (e. g. toothed latches or
moving bolts).
In this way you can prevent the work
mass from sliding down.
24
50 60
M4 M6
[mm] 7 12
[mm] 7x3 9x4
[Nm] 2.9 9.9
Fig. 5
Fig. 6
Fig. 7
Festo EGSA 0711NH English