Fitting; Fitting Mechanical Components - Festo EGSA Instrucciones De Utilizacion

EGSA
5

Fitting

Fitting mechanical components

Do not modify the settings of screws and threaded pins if there is no request to
S
do this in these operating instructions.
Fit the motor on the cantilever axis in ac
S
cordance with the assembly instructions
of the axial/parallel kit recommended in
the catalogue.
Fitting the product
Please note
S Always fasten the EGSA using the lower threaded holes 5 on the basic
profile.
The holes on the side are intended for fastening accessories
(e. g. chain−link trunking).
Make sure that the device is fitted free of
S
mechanical stress and distortion
(evenness of support surface 0.2 mm).
Position the EGSA so that its operating
S
elements can be reached.
Festo EGSA 0711NH English
Fig. 3
Fig. 4
23