DENTAURUM amda Instrucciones De Uso página 20

Fig. 4: The anterior-posterior orientation of the amda
5.1.3.3 Adapting amda
First, check the vertical distance between the amda
molar palatal sheath. The amda
palatal sheath should vertically be at the height of the palatal sheath
and horizontally parallel to the tube of the sheath. The amda
set is delivered with mounted amda
distance between the parallel part of the amda
palatal sheath is larger or smaller, you can use the 13 mm or 7 mm
amda connector. They are included in the starter set. For fine corrections
®
the amda connector can be removed from the retaining tube on the
®
amda telescope. To achieve the desired height and angulation of the
®
insertion element, bend the S-shaped part of the amda
two pliers. To achieve the desired rotation / derotation and uprighting of
the molars, bend the insertion element in the desired direction with two
pliers. Depending on the type and scope of the correction, insert the
amda connector back into the amda
®
At this point (or later), adjust or correct the amda
or rotate the molars.
After the amda
back into the retaining tube on the amda
distalization appliance can now be fitted into in the patient´s mouth.
20
connectors
®
connectors have been aligned, insert the connectors
®
connector element that fits into the
®
connectors (10 mm). If the
®
telescope and check the position.
®
telescope (Fig. 5). The
®
telescope
®
telescope and the
®
®
palatal arch and the
®
connector with
®
connector to upright
®
starter