Denon DVD-2200 Instrucciones De Operación página 14

ENGLISH
(4) Connecting a basic 5.1-channel surround system
Analog 5.1-channel audio signals can be output from the DVD-2200.
The multichannel audio signals recorded in packed PCM and the multichannnel Super audio CDs can be played when an AV amplifier
equipped with analog 5.1-channel audio inputs is connected.
DVD-2200
NOTES:
• For multi-channel connections, set "AUDIO CHANNEL" under "AUDIO SETUP" at "SETUP" to "MULTI CHANNEL" and make the
"SPEAKER CONFIGURATION", "CHANNEL LEVEL" and "DELAY TIME" settings.
• The delay time setting is not valid when playing Super audio CDs.
• Set the "SUPER AUDIO CD" setting under "AUDIO SETUP" to "MULTI".
• With the DVD-2200, we recommend turning the digital output off and only outputting analog signals in order to keep interference from
the digital output circuitry to the minimum and allow you to enjoy high bit, high sampling frequency, high quality multi-channel sound.
14
If necessary, connect the video terminals, referring to page 10.
Front speaker (left)
Surround speaker (left)
AV amplifier with 5.1-channel inpur terminals
Center speaker
SURROUND MODE MULTI FUNCTION
DOLBY DTS WIDE 5CH / 7CH DSP MODE
DIRECT STEREO SURROUND SURROUND SCREEN STEREO SIMULATION STATUS SELECT FUNCTION CONTROL
PHONES
INPUT CINEMA / 6.1 / 7.1 VIDEO TONE REC /
MODE ANALOG EXT. IN MUSIC SURROUND ON / OFF DEFEAT M-ZONE 1 M-ZONE 2
INPUT REC SELECT / M-ZONE
To power outlet
Front speaker (right)
Subwoofer
Surround speaker (right)